Back to Blog
292 ford engine casting numbers location6/23/2023 The difference in a 2004 engine and a 2014 engine serial number is as follows.Example: 2004 engine would be something like 06435, and a 2014 engine would be stamped T0614149. The first engines were stamped 4PO4, and the 2014 engines are stamped 4PO4. GM has come full circle now on the PO4 numbers, so the first method alone is not entirely accurate. Common factory displacements ranged from 239 cubic inches to 312 cubic inches. The 6090 is the Ford code for 'cylinder head' it is on all of them and means nothing. They are: Y-Block small-block: Produced in the US from 1954 until 1964, the Y-Block was the small-block replacement for the Flathead V8 and is where this article starts. Y-Block Cylinder Head Casting Numbers Cylinder head casting numbers can be found under the valve cover on early heads, between the exhaust ports on some heads or under the water passage to the intake manifold. As an example, a 2013 engine would read something like this, 1013426. This article covers a number of Ford V8 engine families. The date code for the engine is built into the serial number after the first two numbers. However, the most accurate way is to look at the serial number on the block, which is located on the drivers side, rear, on the extended part of the deck surface that goes over the bell housing area. For instance a 2009 engine would say 9PO4, a 2006 engine would say 6P04, etc. These numbers are located on the Passenger side front, on a square pad on the deck surface. The first way is to look at the numbers on the front of the block. There are two ways to determine the year your 604 was manufactured.
0 Comments
Read More
Leave a Reply. |